Concrete slab
In a new build, or when the slab is renewed, the pipes are fixed on top of the insulation and cast into the concrete. This suits slabs on the ground and concrete intermediate floors, and it does not raise the floor.
Energy renovation / Underfloor heating
We install LK Systems water-based underfloor heating in new builds and renovations, with an individual design for every property. Underfloor heating works at a low water temperature, which makes it an energy-efficient heat distribution system for an air-to-water heat pump.
The LK Systems range has solutions for new builds and renovations alike. The right system depends on the floor structure and on how much the floor may rise.
In a new build, or when the slab is renewed, the pipes are fixed on top of the insulation and cast into the concrete. This suits slabs on the ground and concrete intermediate floors, and it does not raise the floor.
Heat distribution plates are installed on top of the joists or between sparse boarding, and the floor finish goes directly on top. This also suits older houses whose joist spacing differs from today’s standard.
When the old floor is not removed, thin underfloor heating boards or a thin screed layer are used. The floor rises by as little as about 2–3 centimetres.
Underfloor heating releases heat from the whole floor surface, so it warms the room evenly at a low water temperature. That is exactly what an air-to-water heat pump needs to run energy-efficiently.
Both work at a low water temperature. Underfloor heating is the natural choice for a new build and for a renovation where the floors are being renewed anyway. If the floors are to stay untouched, new energy-efficient radiators are the quicker solution. We go through the options during the site visit. Read about energy renovation.
We find out the floor structure, the permitted build height and the heat demand of the house.
LK Systems makes an individual underfloor heating design for the property: the right system for the floor, the heating circuits and the manifold locations. You get a written quote with labour and materials itemised.
The pipes, manifolds, actuators and room thermostats are installed. The system is pressure-tested before the floor is covered.
The circuits are balanced and we show you how to use the system. We give a one-year warranty on our work.
Yes. In wooden floors, heat distribution plates are installed on top of the joists or between sparse boarding, and there are low-profile board and screed solutions for laying over a concrete floor.
Not at all in a new build. Laid over an existing floor, it raises the floor by as little as about 2–3 centimetres, depending on the structure.
We install LK Systems underfloor heating, and LK Systems makes an individual design for every property. The installation follows the design.
Very well. Underfloor heating works at a low water temperature, which lets the air-to-water heat pump run at its best efficiency.
All common floor finishes, such as tiles, parquet, laminate and vinyl.
In a renovation, yes: the labour share of work in your own home or holiday home qualifies for the Finnish household tax credit (kotitalousvähennys), and we itemise the labour on the invoice. Building a new house does not qualify. The amount and conditions are on vero.fi.
Tell us what kind of floor you are planning underfloor heating for and we will find the right solution. Call or send a message.